EFFECT OF COOLING SLOPE CASTING PARAMETERS ON THE THIXOTROPIC MICROSTRUCTURE OF A356 ALUMINUM ALLOY

Document Type : Original Article

Authors

1 Mechanical Engineering Department – Shoubra Faculty of Engineering – Benha University, Cairo, Egypt.

2 Mining, Petroleum and Metallurgical Department, Faculty of Engineering, Cairo University, Giza, Egypt.

Abstract

In the present paper, the effect of cooling slope casting (CSC) parameters process, typically, pouring temperature (T), cooling slope length (L) and tilt angle (θ), on the microstructure of A356 cast aluminum alloys was studied. The analysis of variance (ANOVA) statistical technique was carried out to clarify the relationship between the aforementioned parameters and the microstructure variables, typically, the shape factor (S.F.) and the grain size (G.S.) of the α-Al primary phase. The uniformity of the microstructure in both the axial and radial positions of the ingots was also evaluated statistically. The results revealed that the tilt angle has the highest significant effect on both shape factor and grain size. The shape factor exhibited maximum value of about 0.812 for ingots poured at θ = 30o, L = 300 mm, T = 630 oC. The minimum grain size was about 32.85 μm for ingots casted at θ= 60o, L = 200 mm, T = 630 oC. Ingots poured at θ = 60o, L = 300 mm, T = 630 oC exhibited the highest grain size uniformity. While ingots casted at θ = 30o, L = 400 mm, T = 620 oC, exhibited the highest shape factor uniformity.

Keywords